Construction Technology 5.02
Quiz
A screwdriver handle is designed to:
- Hammer nails.
- Provide a firm grip.
- Pry open a jammed door.
- Resist grease.
A sledgehammer is used to:
- Break open wooden boxes.
- Drive a post or stake.
- Hammer nails.
- Remove dents from metal.
An adjustable wrench should always be turned so that the:
- Pressure is on the fixed jaw.
- Pressure is on the movable jaw.
- Movable jaw is pointed away from the user.
- Movable jaw is pointed toward the user.
A square is used to:
- Calculate areas of a room.
- Cut wire.
- Mark and measure.
- Pull a nail.
A center punch is used to:
- Level an uneven piece of work.
- Make small locating points to be used for drilling holes.
- Punch holes in light-gauge metal when a drill is not available.
- Wedge a large piece of equipment.
In which capacity ranges are come-alongs available?
- 20 to 100 tons
- 20 to 100 tons
- 8 to 12 tons
- 1 to 6 tons
A chisel is used to:
- Center punch when drilling.
- Cut wood, metal, or stone.
- Deburr conduit and boxes.
- Push off excess debris.
A utility knife is used to cut:
- Conduit.
- Plywood.
- Roofing felt.
- Wire.
What is a proper use of a screwdriver?
- Electrical tester
- Electrical tester
- Punch
- Tighten screws
What tool is used to clean welds?
- Center punch
- Cold chisel
- Hacksaw
- Wire brush
A cat’s paw is a:
- Crushing tool.
- Nail pulling tool.
- Ripping tool.
- Sledge hammer.
Wrenches are used to:
- Pound nails into wood.
- Pry open fitting on drains.
- Strip threaded pipe.
- Strip threaded pipe.
Long-nosed pliers are used to:
- Clamp objects loosely.
- Cut heavy or large-gauge wire.
- Get into tight places where pliers will not reach.
- Hold pipes because the long handles give more leverage.